EPDM Accessories and Fittings

Fitting A Gutter Edge Drip Plate In this tutorial, we’re going to guide you on the fitting of the gutter edge drip plate. Step 1 Make a mark around the edge of the roof, right where it falls over the sides. In this example, there are curved edges on the other two dimensions. Trim all edges down to 50 mm. Step 2 The drip plate is placed in position over the edge of the roof. This traps the EPDM membrane between the back plate and the drip plate. Step 3 The drip plate will secure on to a hook on the back plate and it will snap in to place and secure that edge completely. Step 4 Tap into

EPDM Through-Wall Outlet Detail Using the EPDM outlet accessory In this Permaroof installation guide, we will demonstrate the installation process for through-wall outlet detail using the EPDM Thru Wall Outlet accessory from Permaroof. This method effectively seals and protects internal drain details from water ingress. Once installed correctly, the EPDM Thru Wall Outlet leaves you with a long-lasting, high performance result, perfect for EPDM flat roofing systems. The longevity of EPDM flat roofing can be fully supported using the right accessories for your projects. Ensure a watertight, reliable seal for the long term at critical points such as corners and junctions between roofing and parapet walls. Step One The EPDM membrane should be adhered to the substrate and upstand wall

Pipe flashing detail (Quickseam Formflash) As with any detail, make sure the area is clean and dry. There are 3 pieces of Quickseam Formflash needed to complete this detail, two of which are the same size for the base area, and one to wrap around the pipe. With the crayon, mark out the area to be primed at least 95mm from the pipe. Also mark out 75mm distances as a guideline for applying the Quickseam Formflash. Apply the Quickprime Plus to the outer markings around the pipe, and also approx. 75mm up, and wait until tacky. Round the corners off the Quickseam Formflash, and mate onto the deck in line with the 75mm markings. On the reverse of the tape,

Pipe flashing detail (pre-fabricated pipe boot) As with any detail, make sure the area is clean and dry. Measure the diameter of the pipe… ...and cut out the same diameter on the pipe boot flange… Stretch the boot over the pipe and offer into position onto the deck. With the crayon, mark out the area to be primed approx. 20mm beyond the flange base. Lift the boot upwards to apply the Quickprime plus onto the deck Once the Quickprime Plus becomes tacky, place the boot back into position on the deck and peel away the complete backing paper from underneath. Use the silicon roller to secure the boot to the deck Pull the top of the boot around the neck

Installation of Internal Drain Detail In this Permaroof installation guide, we will demonstrate the installation process for internal drain detail using the EPDM drain outlet accessory. This method effectively seals and protects internal drain details from water ingress. Once installed correctly, the EPDM drain detail leaves you with a long-lasting, high performance result, perfect for EPDM flat roofing systems. Step One The EPDM membrane should be fully adhered to the substrate and the membrane cut away to reveal the drain hole. Step Two Insert the drain outlet... Step Three Mechanically fix the outlet to the roof deck using V-plates and All-purpose fasteners. Step Four Apply Quickprime plus to the area a minimum of 100mm beyond the perimeter of the flange.