Yes, EPDM can be cut in situ using sharp, long-bladed EPDM scissors. Mark the EPDM with a chalk or crayon along the cutting line using a straight edge for the best results. When trimming the overhang edges, such as when fitting a shed roof kit, ensure the line is straight and even, leaving sufficient (approx. 50mm) in place to seal when the battens are replaced.
EPDM systems are fast and easy to install. This has made them popular for DIY on a range of domestic projects, such as: Shed roofing Garage roof replacement Flat roof extensions Garden rooms We provide an extensive range of installation guides and offer expert advice to help you get your projects completed right, first time. Visit the PermaRoof UK resource library or use the downloads section
EPDM requires few tools for installation: Penny and silicone rollers Paint rollers – if using liquid adhesive Chalk and straight edge EPDM scissors Household broom We stock a range of tools, specially selected for installing EPDM, in our online store.
No. Ponded water, snow, frost and ice must be removed from the roof surface before installation of the membrane.
Elevate's QuickPrime Plus primer must be used with ALL Elevate QuickSeam products in order to clean and prime the membrane before their application.
Besides Elevate's QuickScrubber tool and rubber roller, the following tools are needed: scissors, measurer, solvent resistant paint roller, chalk line, bucket, mixer (for Bonding Adhesive), clean rags, broom.
No. The RubberCover EPDM membrane is only suitable for roofs and gutters.
Following materials can be used to insert drains: EPDM, zinc, flexible PVC, galvanized and stainless steel.
The use of double-walled penetrations is required.
Yes, it is possible to cover the membrane with gravel, pavers or bankirai wood but the membrane must always be fully adhered to the substrate. Elevate recommends the use of a protective geotextile (polyester 300 g/m²) between the membrane and the ballast.